产品简介 / PRODUCT BRIEF

雨停高效好洁丽墙面固化底漆是采用优质特细径的丙烯酸合成树脂乳液精制而成，能有效

渗入墙体深层增强附着力，在外墙表面形成致密的耐碱性涂层，封固性强。

The YUTING good wall lepideus primer is made of high quality superfine size acrylic

synthetic resin emulsion can be effectively refined, Deep into the wall to enhance the

adhesion, the alkali resistance coating to form a dense outer surface, strong sealing

performance.

产品特点 / PRODUCTION CHARACTERISTICS

封闭性好，能减少面漆免受基层化学物品的侵蚀

渗透能力优异，能有效提高层间附着力

优良的耐水性能，能保证面漆的附着性能，同时可节省面漆和改善涂膜光泽

流平性好，施工方便

增强腻子层牢固度

Good sealing ability. It can reduce the corrosion of the topcoat from the base chemicals

Excellent penetration ability, can effectively improve interlayer adhesion Excellent water

resistance, can ensure the adhesion of the topcoat, while saving paint and improve coa-

ting gloss Leveling is good, construction is convenient Enhance the firmness of putty layer

适用范围 / SCOPE OF APPLICATION

用于各种砂浆面、混凝土等基面的封闭，特别适用于渗透力高的水性涂装体系使用，能有

效提高层间附着力。

The utility model is used for sealing the base surfaces of various mortar surfaces, co-

ncrete, etc., and is especially suitable for the water coating system with high penetra-

tion forceInterlayer adhesion.

施工指导 / ConTRUCTION GUIDANCE

基层要求：基层要坚固、平整、清洁、干燥（含水率≤10%）、中性（pH值≤10 )。

施工方式：刷涂、辊涂、喷涂

稀释：直接施工，不建议稀释

清洗：工具使用完毕，请立即用清水洗干净

施工条件：施工温度5-35℃，空气湿度不大于85%，大风天气及下雨季节应避免施工。

Basic requirements: basic level should be firm, smooth, clean and dry (water content

less than 10%), neutral (pH = 10).

Construction methods: brushing, roll coating

sprayingDilution: direct construction, no dilution is recommended

Cleaning: after the tool is used, please wash it with clean water immediately Construction

conditions: construction temperature of 5-35 degrees, air humidity is not greater than 85%, windy

weather and rainy season should avoid construction.

技术参数/TECHNICAL DARAMETER

理论涂刷面积：0.1-0.125kg/m/遍（实际用漆量会因施工方法、表面粗糙度等因素影响而有较大差异）

光泽：高光

干燥：表干≤2小时，实干7天/25℃

重涂时间：≥4小时（25℃，50%相对湿度）

Theoretical brushing area: 0.1-0.125kg/m/ times (the actual amount of paint will be due to const-

ruction methods, surface roughness and other factors and there is a big difference)

Gloss: high

glossDry: dry work less than 2 hours, 7 days /25 C

Recoating time: 4 hours (25 DEG, 50% relative humidity)

注意事项 / MATTERS NEEDING ATTENTION

施工时应保持空气流通，应远离阳光直射及热源；

如沾染眼睛，立即用大量清水清洗，并到医院治疗；放置在儿童取不到的地方。

Construction should keep the air circulation, stay awayfrom direct sunlight and heat source;

If infected with eyes, wash immediately with plenty of water, and to the hospital for treatment;

Place where children can't get it.

产品包装 / PACKING OF PRODUCT

15kg/桶 15kg/barrel

10kg/桶 10kg/ barrel